
Water Analysis for Tertiary Treatment of Wastewater

Final Effluent Polishing Before Wastewater Reuse
In tertiary treatment, techniques such as filtration, disinfection, carbon absorption and other processes are used to remove the remaining organic load, suspended or dissolved solids, pathogens and heavy metals that pass through other treatment processes.
Also called effluent polishing, tertiary treatment raises the effluent quality to the level suitable to its intended use, whether for discharge into lakes, rivers, oceans, reuse as non-crop irrigation (parks, golf courses, greenways, etc.), groundwater recharge or in certain cases, as influent to drinking water plants.
Wastewater plant effluent must be monitored to ensure compliance with effluent permit limits, which vary based on jurisdiction and country.
Over 200 Pre-Programmed Methods
Customer Challenges

Chemical Dosing
Chemical Dosing
- Adequately dosing of the chemical prior to filtration. Inefficient dosing could lead to higher costs, possible clogging of the filter, and compliance issues
- Chemicals could be a coagulant and/or a flocculant
Filtration
- Filter fouling and appropriate backwash and cleaning cycles are important to monitor to optimize costs in energy consumption and ensure efficient SS removal
- Filter breakthrough may increase TSS even higher than inlet (drum filter, cloth filters, sand filter)
Settling
- Utilize chemicals and the challenge is to dose in relation to the pollution
- Instead of filtration settling is utilized; clogging is not an issue, however sludge level must be monitored

Polish the Effluent for Micropollutants
Ozonation
- Adequate dosing of the ozone (inefficiency leads to high costs)
- Meeting compliance for micropollutants and elimination rate
- Monitoring energy consumption
- Nitrite leads to higher ozone consumption
Powdered Activated Carbon
- The loss of activated carbon in the effluent
- Higher sludge production if you use activated carbon
- Meeting compliance for micropollutants and elimination rate
- Need to identify when to reactivate carbon
Granular Activated Carbon
- Filter fouling and appropriate backwash and cleaning cycles are important to monitor to optimize costs in energy consumption and ensure efficient MS (micropollutants) removal
- Need to identify when to reactivate carbon (if not monitored can become saturated and will not absorb micropollutants anymore)

